Material Insights · Understanding the Material World

Latent heat: Technologies

Technologies

The technologies that rely on it, and how each one uses it

Relied on by 25
Show 15 more
  • LAES Liquid air storage Making liquid air means taking out its latent heat; when the liquid boils back to gas it takes heat in again and expands to drive a turbine.
  • LNG LNG chain Natural gas is cooled until it condenses, so refrigeration must remove its latent heat of condensing as well as the heat of cooling it.
  • Cold LNG cold and cryogenic recovery Turning LNG back into gas takes in its latent heat, which makes the regasifying liquid a source of cold for other uses.
  • WHU Waste heat for drying, water and food Drying a product with waste heat means supplying the latent heat that evaporates the water in it.
  • AWH Atmospheric water harvesting Water vapour gives out its latent heat as it condenses on a cold surface, and that heat must be carried away for condensing to go on.
  • QF Quick freezing of food Freezing food means removing the latent heat of the water in it, which takes far more cooling than chilling it by a few degrees.
  • Cst Metal casting (lost wax) Metal must take in its latent heat of melting before it can be poured, and gives that heat back as it sets in the mould.
  • DHN District heating and cooling networks First-generation networks carried heat as steam, which gives up its large latent heat when it condenses in the building.
  • GSH Geothermal direct use and ground-source heat pumps The heat pump's refrigerant takes up heat as it evaporates in the exchanger with the ground loop and gives it out as it condenses indoors.
  • GeP Geothermal power plants Flash plants boil hot water into steam by dropping its pressure, and binary plants boil a second fluid with a lower boiling point.
  • PB Gypsum plasterboard In a fire the bound water must be driven off as steam before the core heats up, which delays heat passing through the board.
  • Thm Liquid-in-glass thermometer Scales are fixed at changes of state, such as melting ice and boiling water, which happen at a steady temperature because the heat goes into changing state; Fahrenheit used both points.
  • Heat pump The refrigerant takes up heat when it boils and gives it up when it condenses.
  • Industrial boiler Most of the heat in steam is the latent heat of boiling, and condensing designs win back the latent heat of the water vapour in the exhaust.
  • Steam turbine Boiling takes in and condensing gives out a large amount of heat at one temperature.
Limits 6
  • Ds Distillation Every kilogram of liquid boiled off needs its latent heat of vaporisation, which is why distillation uses so much energy.
  • AWH Atmospheric water harvesting Capturing vapour gives off heat, as the 2017 study notes for its exothermic adsorption, and the same heat must be put back to release it, which sets the energy each litre needs.
  • BmC Biomass combustion and CHP Water in fresh wood must be boiled off in the furnace, which uses up part of the fuel's heat.
  • Corrugated box The base paper must be dried, which means evaporating water from the wet sheet, the largest energy use at the mill.
  • Cotton T-shirt A wet T-shirt can only dry by evaporating its water, so tumble drying needs a fixed amount of heat per kilogram of water.
  • PM Continuous paper machine Every kilogram of water left after pressing must be evaporated, which takes much heat; this is why the dryer section dominates a mill's energy use.

as of 2026-11-11