Gas turbines and combined cycle: Science
Principles
The science it rests on, with why each principle matters to it
Relies on- Combustion chemistry Burning natural gas in compressed air releases the heat that the turbine turns into work.
- Bernoulli's principle Shaped blades speed up and turn the gas flow, trading pressure for speed and pushing the rotor round.
- Gas laws Heating the compressed air raises its volume flow, so the turbine gives out more work than the compressor takes in.
- Carnot's limit on heat engines Efficiency rises with the gap between the turbine inlet temperature and the surroundings [8], so designers push inlet temperatures ever higher.
as of 2026-11-10
Discoveries
The discoveries that made it possible: when, by whom and what was found
| Year | Who | What |
|---|---|---|
| 1824 | Sadi Carnot | Showed that a heat engine's work is capped by the temperatures it works between [8] |
| 1850 | Rudolf Clausius | Confirmed Carnot's theorem, the basis of the second law of thermodynamics [8] |
| 1903 | Ægidius Elling | Built the first gas turbine to give more work than its compressor used; it produced 8 kW [1] |
as of 2026-11-10
Physical limits
The limits nature sets, today's best and how far there is still to go
| Limit | Unit | Best today | Gap |
|---|---|---|---|
| Carnot limit between the turbine inlet temperature and the surroundings | % | Above 64% for a combined-cycle plant with one M501JAC turbine, lower heating value [4] | Losses in compression, combustion, blade cooling and the exhaust heat that even a steam cycle cannot use |
| Turbine inlet temperature set by what blade alloys and cooling can survive | °C | J-class inlet temperature 100 °C above the G class before it [4] | Higher temperatures need better superalloys, ceramic coatings and cooling |
as of 2026-11-10
The science explained
The science behind it explained for a curious reader
A gas turbine is a heat engine that never stops: instead of pistons going up and down, air flows through it in a steady stream. The compressor takes work to squeeze the air, and the turbine gives back more work than that because the air has been heated in between and now takes up far more room. Carnot showed in 1824 that the share of heat that can become work depends on how hot the heat source is compared with the surroundings [8]. That is why makers chase hotter turbine inlets, with blades cooled from inside and coated in ceramic. Even so, the exhaust leaves hot enough to boil water. A combined-cycle plant catches that heat to run a steam turbine, and the pair together turn over 60% of the fuel into electricity [3].
as of 2026-11-10
Sources
- About NFTS: Father of the gas turbine Norwegian University of Science and Technology (NTNU), Norwegian Gas Turbine Society
- GE HA Turbine Snags Another World Record for CCGT Efficiency POWER Magazine, 2018
- M501J series gas turbine specifications Mitsubishi Power, 2026
- Carnot, Nicolas Léonard Sadi Encyclopedia.com (Encyclopedia of World Biography; Complete Dictionary of Scientific Biography)