Material Insights · Understanding the Material World

Electrical discharge machining

Sparks erode hard metal into precise shapes such as moulds and dies.

Making things · Tools and machining · No. 496

  • Electronic age
  • Readiness 9 of 9
  • Process
Making things · Technology

A failed attempt to stop sparks wearing away switch contacts became a way to carve the hardest steel to within microns.

Chart: Illustration: Electrical discharge machining

Where it comes from

Chart: Map of where it comes from

In 1943 Boris and Natalia Lazarenko, working in Moscow, saw that sparks under a fluid removed metal in a controlled way. By 1946 the method was patented abroad and entering Soviet factories, and Swiss firms showed production machines in 1954.

Three things to know
  1. The Lazarenkos found the method in 1943 while trying to stop sparks eroding tungsten contacts.
  2. Hardness does not matter: any metal that conducts electricity can be cut, which is why it shapes hardened steel moulds.
  3. Computer numerically controlled spark machines appeared in the United States in 1980.
The journey
  1. 1 ElectrodeA shaped copper or graphite tool, or a moving thin wire
  2. 2 FluidTool and workpiece sit in oil or deionised water
  3. 3 SparkVoltage pulses make sparks jump the tiny gap in rapid succession
  4. 4 ErosionEach spark melts and vaporises a speck of metal, flushed away by the fluid
  5. 5 PartA mould cavity, die or turbine slot in hardened metal
Go deeper pick a tab to open it in full