Material Insights · Understanding the Material World

Electrical discharge machining: Science

Principles

The science it rests on, with why each principle matters to it

Relies on
  • Electrostatics (Coulomb's law) The voltage across the gap pulls charges through the fluid until it breaks down and a plasma channel forms [4], which is the spark that does the cutting.
  • Heat conduction (Fourier's law) Each spark heats a spot enough to vaporise it [4]; copper electrodes wear less than brass because of their high thermal conductivity and melting point [4].

as of 2026-11-11

Discoveries

The discoveries that made it possible: when, by whom and what was found

YearWhoWhat
1770Joseph PriestleyNoticed that a series of electric sparks wears away the surface they strike [4]
1943Boris and Natalia LazarenkoFound that sparks in a dielectric fluid remove metal in a controlled way [1, 2]

as of 2026-11-11

The science explained

The science behind it explained for a curious reader

Imagine a lightning storm in miniature. The tool and the metal part are the cloud and the ground, a hair's breadth apart, with oil or water between them. Raise the voltage and the fluid suddenly gives way: a thin thread of plasma forms and a spark leaps across [4]. Where it lands, the metal is heated so fast that a tiny pool melts and boils off [4]. Then the pulse stops, the fluid rushes back, quenches the spot and carries the speck away [3]. Each spark removes almost nothing, but a rapid stream of them adds up. Because the cutting is done by heat, not force, the hardness of the metal hardly matters; it only has to conduct electricity [4].

as of 2026-11-11

Sources

  1. Boris Lazarenko - Institute of Applied Physics Institute of Applied Physics, Chisinau, Moldova
  2. ОБ ОТКРЫТИИ И РАЗВИТИИ ЭЛЕКТРОЭРОЗИОННОЙ ОБРАБОТКИ МАТЕРИАЛОВ. К 60-ЛЕТИЮ ОТКРЫТИЯ СПОСОБА B. N. Zolotykh, Elektronnaya Obrabotka Materialov, vol. 39, no. 3 (abstract in English), 2003
  3. Sparks of precision UNITED GRINDING Group, Motion magazine (a machine builder's customer magazine), 2025
  4. A review on optimization of machining performances and recent developments in electro discharge machining B. Nahak and A. Gupta, Manufacturing Review, vol. 6, article 2, 2019