Material Insights · Understanding the Material World

Injection moulding

Molten plastic is forced into a steel mould, making identical parts in seconds.

Making things · Forming and joining · No. 333

  • Electrical and chemical age
  • Readiness 9 of 9
  • Process
Making things · Technology

Patented in 1872 to shape celluloid, injection moulding now turns out Lego bricks, cutlery and medical parts, small ones several a minute.

Chart: Illustration: Injection moulding

Where it comes from

Chart: Map of where it comes from

John and Isaiah Hyatt, celluloid makers in Albany, New York, patented a heated cylinder that forced the softened plastic through a nozzle into a mould in 1872. The method only became a commercial success with cellulose acetate, after 1928.

Three things to know
  1. The Hyatt brothers' 1872 patent used a plunger in a heated cylinder to force celluloid through a nozzle into a mould.
  2. James Hendry replaced the plunger with a turning screw in 1946, which gave better control of injection speed and part quality.
  3. The reciprocating screw, which both melts and injects, was developed at Egan Machinery in 1952 and patented in 1956.
The journey
  1. 1 PolymerOil or gas is made into plastic pellets
  2. 2 MeltingA turning screw in a heated barrel melts the pellets
  3. 3 InjectionThe screw pushes forward like a plunger and fills the mould
  4. 4 CoolingThe plastic sets against the cold steel walls
  5. 5 EjectionThe mould opens and pins push the finished part out
Covered in The economics of a chemical plant: costs, prices and profitChemicalsFrom building blocks to plastics, fibres and detergentsChemicals
Go deeper pick a tab to open it in full