Injection moulding: Materials
Materials it needs
The commodities and chemicals it needs per unit, its share of each one's demand and how critical each is
Processes 6- PP Polypropylene criticality low A common moulding plastic for caps, crates and car parts.
- LLDPE Polyethylene (LDPE, LLDPE) criticality low One of the commonest moulding thermoplastics [3], used for lids, containers and household goods.
- ABS ABS criticality low A tough plastic moulded into toy bricks and appliance housings.
- PS Polystyrene and EPS criticality low A common moulding thermoplastic [3], used for cutlery, model kits and packaging.
- PC Polycarbonate criticality low Moulded into clear, impact-resistant parts such as lenses and covers.
- PA Nylon (PA6, PA66) criticality low Polyamide is a common moulding thermoplastic [3], used for gears, clips and parts that must resist heat and wear.
- St Steel criticality low Production moulds are usually cut from hardened tool steel so they survive many cycles; short-run moulds may be aluminium [11].
as of 2026-11-11. No source gives material amounts per part; criticality is the writer's judgement: the plastics are made in huge amounts from oil and gas and the mould steels are widely available.
Critical materials
The materials whose supply could hold it back
- No material is likely to hold injection moulding back: the main plastics and mould steels are made in very large amounts.
- Fossil feedstocks: plastics are made mostly from oil and gas, and only 15.4% of production in 2024 was post-consumer recycled, bio-based or carbon-captured [5].
as of 2026-11-11
Sources
- Injection moulding Museum of Design in Plastics, Arts University Bournemouth
- Plastics the Fast Facts 2025 Plastics Europe (October 2025), 2025
- Leveraging low-volume injection moulding Protolabs