Material Insights · Understanding the Material World

Chemical reactions: energy, rates, acids and bases, oxidation: Energy in reactions: bonds, barriers and fuels

All courses / Understanding Science / Module 11: Chemical reactions: energy, rates, acids and bases, oxidation Part 2 of 6

Energy in reactions: bonds, barriers and fuels

Some reactions warm their surroundings and some cool them. This part explains why, using the energy of bonds, shows why a fuel can sit in air for years and then burn at a spark, and ranks fuels and foods by the energy in each kilogram. It also meets the surprise that a reaction can run uphill in heat and still go.

2.1 The heat of a reaction is the energy spent breaking the old bonds minus the energy returned as new bonds form

Stir baking soda into lemon juice and it fizzes and feels cool. A gas stove gets hot. Both are reactions, yet one takes in heat and the other gives it out. The first kind is called endothermic and the second exothermic.

The cause lies in the bonds. Holding two atoms together lowers their energy, so pulling them apart always costs energy, and joining them always gives it back. A reaction breaks some bonds and makes others. If the new bonds return more than the old ones cost, the extra leaves as heat. If they return less, the shortfall is drawn from the surroundings. A common slip is to think that breaking a bond releases energy. It does the reverse; the release comes from the bonds that form.

The table adds up two cases from typical bond energies (module 10 explains what a bond energy is). Hydrogen burning in chlorine, the reaction a chlor-alkali plant uses to make hydrochloric acid, comes to minus 186 kJ for two moles of HCl, against a measured minus 184.6. Splitting ammonia back into nitrogen and hydrogen, which is how ammonia could carry hydrogen as a fuel, comes to plus 93 kJ, close to the measured plus 91.8. Understanding Engineering, in the module Matter and process, runs the same tally for natural gas.

Data Two bond-energy ledgers (calculated from typical bond energies)
StepHydrogen with chlorine: H2 + Cl2 -> 2 HClAmmonia cracking: 2 NH3 -> N2 + 3 H2
Bonds broken (cost)1 H-H at 436 + 1 Cl-Cl at 242 = 678 kJ6 N-H at 391 = 2,346 kJ
Bonds made (return)2 H-Cl at 432 = 864 kJ1 N-N triple at 945 + 3 H-H at 436 = 2,253 kJ
Net (cost minus return)minus 186 kJ, so heat given outplus 93 kJ, so heat taken in
Per moleminus 93 kJ per mole of HClplus 46.5 kJ per mole of NH3 split
Measured valueminus 92.3 kJ per mole of HClplus 45.9 kJ per mole of NH3

Bond energies in kJ per mole are averages over many molecules, so agreement within a few kJ is expected. Measured values are standard enthalpies of formation at 25 degrees C, with the sign reversed for the cracking.

Source: University of Texas at Austin, General Chemistry help sheet, Bond energies, https://gchem.cm.utexas.edu/pdf/helpsheets/bondenergies.pdf (average bond energies in kJ/mol: H-H 436, H-Cl 432, Cl-Cl 242, N-H 391, N triple N 945, O=O 498, O-H 463, C-H 413, C=O 799; checked 2026)
  • Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
  • University of Texas at Austin, General Chemistry help sheet, Bond energies · web
  • Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook · values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them

2.2 A downhill reaction still needs a push over an energy barrier, which is why fuel can sit in air for years

Wood, paper and petrol are all in contact with oxygen, and burning would release a great deal of energy. Yet a cupboard of papers does not catch fire. The reason is the activation energy. To rearrange atoms, some old bonds must first be stretched and loosened before the new ones tighten. Picture a ball in a hollow on a hillside, with lower ground beyond a ridge. The ball would gain energy by rolling down, but it first has to be lifted to the top. The height of the ridge is the activation energy.

At room temperature almost no collisions between molecules carry that much energy. A spark, a hot wire or a struck match supplies a local patch of heat. A few molecules cross the ridge and release their energy as heat, which lifts their neighbours over, and the reaction sustains itself. The height of the barrier is not set by the energy released, so a strongly exothermic reaction can still be very slow.

A mixture of hydrogen and chlorine shows that the push need not be heat. Kept in the dark, the two gases barely react; in bright light they can explode. Light of wavelength shorter than about 494 nm carries enough energy per photon to split a chlorine molecule (calculated in the table). Each loose chlorine atom then starts a chain of steps, shown in the table, that repeats many times. Fuels also differ in how big a push they need. Petrol gives off enough vapour to ignite from a spark even on a cold night, since its flash point is around minus 40 degrees C. Diesel's flash point is typically above 50 degrees C, so a spark at ordinary temperatures does little.

Data An energy journey for hydrogen and chlorine (calculated)
StageEnergy relative to the reactantsWhat is happening
Reactants (H2 + Cl2)0Stable in the dark; the molecules meet but rarely react
The push242 kJ to split a mole of Cl2Light shorter than 494 nm: (6.626 x 10^-34 J s x 3.00 x 10^8 m per s x 6.022 x 10^23 per mol) / 242,000 J per mol = 4.94 x 10^-7 m
Chain stepsSmall barriersCl + H2 → HCl + H, then H + Cl2 → HCl + Cl; each atom freed restarts the cycle
Products (2 HCl)About minus 185 kJMeasured 92.3 kJ per mole of HCl, times two; the extra energy leaves as heat

Photon energy is Planck's constant times the speed of light divided by the wavelength (module 7); times the Avogadro constant it gives the energy per mole of photons.

Source: University of Texas at Austin, General Chemistry help sheet, Bond energies, https://gchem.cm.utexas.edu/pdf/helpsheets/bondenergies.pdf (average bond energies in kJ/mol: H-H 436, H-Cl 432, Cl-Cl 242, N-H 391, N triple N 945, O=O 498, O-H 463, C-H 413, C=O 799; checked 2026)

2.3 Fuels and foods differ widely in the energy in each kilogram, and a reaction need not give out heat to go

The energy per kilogram depends on how much bond energy a mass of fuel can hand over. Hydrogen is best, at about 120 MJ per kg, because its atoms are the lightest and each O-H bond it forms in water is strong. Petrol and cooking gas, which are mostly hydrogen and carbon, give about 44 to 46 MJ per kg. Coal is mostly carbon, and Indian coal also holds ash and moisture, so a kilogram offers about 15 to 20 MJ. Dry wood gives about 16. Fuels that already hold oxygen, such as sugar at about 16 MJ per kg, have less left to give, and ash or water cannot burn at all. Fat, nearly all carbon and hydrogen, gives about 37 MJ per kg, which is why the body stores energy in it. Energy density in batteries is far lower, about 0.5 to 0.9 MJ per kg for a lithium-ion pack (see Part 4).

The baking soda and lemon juice from earlier appears to break a rule. It cools, so heat is absorbed, and yet it goes by itself. The explanation is that heat is only half of the matter. The reaction makes carbon dioxide gas from solids and liquids, and spreading matter and energy into many more arrangements is a strong push of its own (module 5, entropy). Whether a change goes depends on both: heat released and disorder gained. Chemists combine them into one quantity called free energy.

Data Energy per kilogram of some fuels, foods and stores (typical values)
MaterialEnergy per kgComment
Hydrogenabout 120 MJLowest heating value; very light but bulky as gas
LPG (propane)about 46 MJStored as liquid under pressure
Petrolabout 44 MJMixture of hydrocarbons
Fat or oilabout 37 MJBody store; 9 Calories per gram
Indian thermal coalabout 15 to 20 MJAsh and moisture lower the figure
Dry woodabout 16 MJContains some oxygen
Glucose or sugarabout 16 MJAbout 3.7 Calories per gram
Lithium-ion battery packabout 0.5 to 0.9 MJStores electricity, not fuel

Fuel values are lower heating values (hydrogen 120.0, propane 46.4, petrol 43.4 MJ per kg in the source); food and coal values depend on composition. Understanding Energy gives fuel data in full.

Source: Engineering ToolBox, Fuels: higher and lower calorific values, https://www.engineeringtoolbox.com/fuels-higher-calorific-values-d_169.html (lower heating values in MJ/kg: hydrogen 120.0, methane 50.0, propane 46.4, petrol 43.4, ethanol 26.7, dry wood 15.4; carbon 32.8 higher heating value; checked 2026)
  • Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
  • Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook · values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them
  • Engineering ToolBox, Fuels: higher and lower calorific values · web

See it in the table

H₂O WaterGas Natural gasLi LithiumGr GraphiteCaO LimeSu SugarHCl Hydrochloric acidCl2 ChlorineH2 HydrogenO2 OxygenCO2 Carbon dioxideNH3 Ammonia

Check your understanding

For 2 NH3 -> N2 + 3 H2 the bonds broken cost 2,346 kJ and the bonds formed return 2,253 kJ. What follows?

The cost exceeds the return by 93 kJ, so heat must be supplied. That is why ammonia is cracked back to hydrogen over a hot catalyst.

A bag of straw sits in air for months without burning, though burning releases a lot of heat. Why?

The energy released is the difference between start and finish. The barrier in between is separate and must be crossed first, with a spark or heat.

An instant cold pack gets colder as the contents react or dissolve. How can this happen by itself?

Spontaneous change depends on both heat and disorder. Where the entropy gain is large, an endothermic process can still run.
← Part 1: Writing a reaction down and counting what goes in and outMark read · Part 3: How fast and how far: rates, catalysts and equilibrium →