Chemical reactions: energy, rates, acids and bases, oxidation: Oxidation and reduction: electrons on the move
All courses / Understanding Science / Module 11: Chemical reactions: energy, rates, acids and bases, oxidation Part 4 of 6Oxidation and reduction: electrons on the move
A rusting gate, a phone battery, a hydrogen fuel cell and a gas flame look unrelated, yet in all four electrons pass from one substance to another. This part defines oxidation and reduction as that transfer, building on the energy of Part 2,, then follows it through corrosion, batteries and fuel cells, and combustion, ending with the carbon dioxide each fuel yields for the energy it gives.
4.1 Oxidation is the loss of electrons and reduction is the gain, and neither can happen without the other
Dip a clean iron nail in blue copper sulphate solution. After a few minutes it wears a pink-brown coat of copper, and the blue fades. Iron atoms have passed electrons to copper ions: Fe → Fe2+ + 2 e-, and Cu2+ + 2 e- → Cu. The first half is oxidation, in which electrons are lost, and the second is reduction, in which they are taken up. Electrons cannot be left lying about, so the two always occur together as a redox reaction. The substance that takes the electrons is the oxidising agent, and the one that gives them is the reducing agent.
The word oxidation began with oxygen, as in burning magnesium: 2 Mg + O2 → 2 MgO. Magnesium atoms lose two electrons each and become Mg2+, oxygen gains them and becomes O2-. The wider definition covers cases in which oxygen is absent. Chlorine gas converts iron to iron chloride, and iron is oxidised there too.
Metals can be ranked by how readily they give up electrons. In the list potassium, sodium, calcium, magnesium, aluminium, zinc, iron, lead, copper, silver, gold, each metal can push electrons on to the ions of those below it. That is why iron takes copper from the solution but not zinc, why gold is found uncombined, and why aluminium, holding on to oxygen hard, was isolated only in the 19th century and needs electrolysis today (see the science node Faraday's laws of electrolysis).
Life runs on redox. In respiration, glucose gives electrons in many small steps to oxygen, which becomes water; photosynthesis drives the same path backwards with light.
| Metal | Reaction with water or dilute acid | Usual state in nature |
|---|---|---|
| Potassium, sodium | Violent with cold water | Only in compounds |
| Calcium, magnesium | Calcium reacts with cold water; magnesium with hot water or acid | Only in compounds |
| Aluminium, zinc | Reacts with acid; aluminium is shielded by an oxide film | Only in compounds |
| Iron, lead | Iron reacts slowly with acid | Compounds |
| Copper, silver | No reaction with dilute acid | Sometimes free |
| Gold | No reaction | Free as metal |
Higher metals reduce the ions of lower ones: Zn + CuSO4 → ZnSO4 + Cu works, Cu + ZnSO4 does not.
Source: Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook, values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook · values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them
4.2 Rust is a small electrochemical cell on the surface of iron, which water and salt speed up and coatings or alloying can slow
Iron kept dry rusts hardly at all, and iron kept in moist air or salt water rusts quickly. Rusting needs water, oxygen and a way for charge to move. On a damp patch, one spot becomes an anode, where iron is oxidised: Fe → Fe2+ + 2 e-. The electrons run through the metal to another spot, the cathode, where oxygen is reduced: O2 + 2 H2O + 4 e- → 4 OH-. Ions in the water film carry charge between the two. The Fe2+ meets OH- and is oxidised further by air into reddish hydrated iron oxide, rust. Salt makes the water film a better conductor, which is why iron rusts faster on the coasts of Mumbai and Chennai.
Rust is also a poor shield. It is porous and flakes, so fresh iron lies under it. Aluminium behaves differently: its oxide forms a thin, tight film that seals the metal (see the science node Passivation and corrosion resistance). Stainless steel works the same way, using at least about 10.5 per cent chromium.
The Delhi iron pillar, about 7.3 m tall and about six tonnes, was made near AD 400 and has stood in the open for some 1,600 years. Studies attribute its survival to about 0.25 per cent phosphorus, which helps a dense protective layer of iron oxyhydroxide form on the surface.
Other defences are painting, which excludes water, and galvanising, which coats steel in zinc. Zinc gives up electrons more readily than iron, so even where scratched it corrodes in place of the steel. A storage water heater uses the same trick: its steel tank holds a replaceable magnesium rod that corrodes first.
| Question | Working | Result |
|---|---|---|
| How much heavier is 1 kg of iron once fully rusted? | Fe2O3: 159.7 / (2 x 55.8) = 1.43; as FeOOH: 2 x 88.9 / 111.7 = 1.59 | 1.4 to 1.6 kg of rust |
| Zinc on a standard galvanised sheet, 275 g per m2 over both faces | 137.5 g per face / 7.14 g per cm3 = 19.3 cm3 per m2, over 10,000 cm2 = 19 micrometres | 19 micrometres per face |
| How long does that coating last? | Assume zinc loses 1 micrometre per year in moderately polluted air | about 19 years |
The 1 micrometre per year figure is an assumed round value; real rates depend on humidity, salt and pollution.
Source: NACE International IMPACT study (2016), as summarised by Johnson Matthey, https://www.jm.com/en/blog/2017/march/nace-study-estimates-global-cost-of-corrosion-at-25-trillion-annually/ (global cost of corrosion about US$2.5 trillion a year, about 3.4 per cent of world GDP; best practice could save 15 to 35 per cent)- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- R. Balasubramaniam, as reported in IUPAC Chemistry International, 27(6), 2005 (Veazey) · web
- NACE International IMPACT study (2016), as summarised by Johnson Matthey · web
4.3 A battery splits a redox reaction in two and sends the electrons round a wire, and a fuel cell does the same while fuel is fed in
Zinc dropped in copper sulphate reacts at once and only warms the beaker. Separate the two halves so that electrons must go through an outside wire, and the same reaction does useful work. In a zinc and copper cell, zinc at the anode is oxidised and electrons flow through the wire to the copper cathode, where copper ions are reduced. A porous partition lets ions drift across to keep each side neutral. The voltage, about 1.1 V, depends on how differently the two metals hold their electrons (see module 6, Electricity and magnetism, and the science node The electrochemical cell). Cells are stacked in series: six lead-acid cells of about 2 V make the 12 V of a car battery.
Recharging forces current backwards with outside energy, reversing the reaction. A lithium-ion cell does it with lithium ions that move between a graphite layer and a metal oxide layer through the electrolyte, while electrons go through the wire.
A fuel cell resembles a battery, except that its reactants arrive from outside. William Grove made one in 1839 with hydrogen and oxygen on platinum. Hydrogen gives up electrons at the anode: H2 → 2 H+ + 2 e-. The electrons pass round the circuit. The protons cross a membrane, and at the cathode oxygen meets them: O2 + 4 H+ + 4 e- → 2 H2O. The only product is water. Space programmes of the 1950s and 1960s drove its development. Understanding Energy covers hydrogen and fuel cells in depth.
| Case | Working | Result |
|---|---|---|
| Phone battery, 5,000 mAh at 3.85 V | Energy = 5 Ah x 3.85 V = 19.3 Wh = 69 kJ | 69 kJ |
| Lithium moved through the cell | Charge 5 Ah x 3,600 = 18,000 C; moles of electrons = 18,000 / 96,485 = 0.187; mass of Li = 0.187 x 6.94 g | about 1.3 g, in a cell weighing about 75 g (assumed) |
| Hydrogen in a fuel cell, 1 kg | 496 mol H2 x 2 electrons x 96,485 C = 9.6 x 10^7 C | 9.6 x 10^7 C |
| Electrical energy at 0.7 V per cell | 9.6 x 10^7 C x 0.7 V = 67 MJ = 18.6 kWh | About 56% of the 120 MJ in 1 kg |
Faraday constant 96,485 C per mole of electrons. The 0.7 V working voltage is typical; the ideal is about 1.2 V. See also Understanding Chemicals: Battery electrolytes.
Source: Encyclopaedia Britannica, Fuel cell: development of fuel cells, https://www.britannica.com/technology/fuel-cell/Development-of-fuel-cells (William Grove used hydrogen and oxygen on platinum electrodes in 1839; space programmes of the 1950s and 1960s drove development)- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- Encyclopaedia Britannica, Fuel cell: development of fuel cells · web
- Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook · values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them
4.4 Combustion is a self-sustaining fast oxidation, and fuels differ in how much carbon dioxide they release for the heat they give
Fire needs three things: fuel, oxygen and enough heat to start and keep the reaction going. Remove any one and it goes out. Water cools, a lid or foam shuts out the oxygen, and a closed valve takes away the fuel. In a flame, solid fuels such as wood first break down under heat into vapours, and it is the vapours that burn. Inside the flame, short-lived fragments pass the reaction along in a chain, faster than the molecules could on their own.
With plenty of air, a hydrocarbon burns completely to carbon dioxide and water, as in C3H8 + 5 O2 → 3 CO2 + 4 H2O, and the flame of a gas stove is blue. When air is short, burning is incomplete. Some carbon ends as soot, tiny particles that glow yellow, and some as carbon monoxide: 2 C + O2 → 2 CO. Carbon monoxide is colourless and odourless and binds to the oxygen carrier in blood much more firmly than oxygen does, so burning fuel in an unventilated room is hazardous. A yellow flame on a gas ring is a sign of too little air.
Respiration is combustion carried out slowly: glucose and oxygen give carbon dioxide and water, as a flame does in principle, but the energy is passed on in small steps to a carrier molecule and not released as one blaze. See the science node Combustion chemistry, and Understanding Energy for fuels in depth.
Carbon is the culprit for climate. Each carbon atom burnt yields one CO2, so fuels with more hydrogen release less of it for the same heat.
| Fuel | Kg CO2 per kg fuel | Heat per kg fuel (MJ) | MJ per kg CO2 |
|---|---|---|---|
| Hydrogen (H2) | 0 | 120 | no CO2 at the point of use |
| Methane (CH4) | 2.74 | 50 | 18 |
| Propane (C3H8) | 2.99 | 46 | 15 |
| Petrol (octane, C8H18) | 3.08 | 44 | 14 |
| Ethanol (C2H5OH) | 1.91 | 27 | 14 |
| Carbon (graphite) | 3.67 | 33 | 9 |
CO2 per kg = (carbon atoms x 44) / molar mass. Heat values are typical lower heating values; carbon is the limiting case for coal, which also holds ash.
Source: Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook, values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook · values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them
See it in the table
H₂O WaterCu CopperAl AluminiumZn ZincSt SteelCr ChromiumAu GoldAg SilverPt PlatinumLi LithiumGr GraphiteMg MagnesiumNaCl SaltCl2 ChlorineCheck your understanding
In Zn + Cu2+ -> Zn2+ + Cu, which statement is correct?
Zinc loses two electrons (oxidation) and copper ions gain them (reduction). The substance that gives the electrons is the reducing agent.Why does a scratched galvanised sheet still resist rust near the scratch?
Zinc sits higher in the activity list, so it is the anode and is oxidised in place of the steel, even where the coating is broken.A smoky yellow flame on a gas ring most likely signals what?
With enough oxygen the hydrocarbon burns completely to CO2 and water with a blue flame. A yellow flame glows with unburnt soot, so burning is incomplete.