Chemical reactions: energy, rates, acids and bases, oxidation: How fast and how far: rates, catalysts and equilibrium
All courses / Understanding Science / Module 11: Chemical reactions: energy, rates, acids and bases, oxidation Part 3 of 6How fast and how far: rates, catalysts and equilibrium
Whether a reaction can happen and how quickly it does are separate questions. This part explains what sets the speed: temperature, concentration, surface area and catalysts. It then shows why many reactions stop short of completion, and how Le Chatelier's rule predicts what a push on a balanced system will do.
3.1 Reactions speed up steeply with temperature, because heat raises the share of collisions that carry enough energy to cross the barrier
Dal softens faster in a pressure cooker, a tablet fizzes faster in warm water, and an egg hardens quicker on a hotter pan. In all of them molecules must collide, and only collisions with at least the activation energy lead to a reaction. Higher temperature helps in a way that surprises many people. The number of collisions rises only a little, about 2 per cent for a 10 degree rise near room temperature. What rises sharply is the share of collisions energetic enough. Svante Arrhenius showed in 1889 that the rate is proportional to e raised to the power minus Ea / RT, where Ea is the activation energy, R is 8.314 J per mole per kelvin and T is the absolute temperature.
A school experiment shows it. Sodium thiosulphate solution is mixed with acid, and a cloud of fine sulphur slowly builds up and hides a cross drawn under the flask. The time for the cross to vanish is measured at several temperatures from 15 to 55 degrees C, and 1 / time is taken as the rate. For an activation energy of 60 kJ per mole the table predicts what you would see: a rise from 20 to 30 degrees C more than doubles the rate, and a rise to 40 degrees C makes it nearly five times faster. The old rule that a 10 degree rise doubles the rate is a good guide for Ea of 50 to 60 kJ per mole near room temperature, but it is only a rule of thumb. Understanding Engineering (Matter and process) applies the same factor to food storage and reactors.
| Temperature | Rate relative to 20 degrees C | Time if 20 degrees C takes 100 s |
|---|---|---|
| 10 degrees C (283 K) | 0.42 (2.4 times slower) | about 240 s |
| 20 degrees C (293 K) | 1.0 | 100 s |
| 30 degrees C (303 K) | 2.25 | about 44 s |
| 40 degrees C (313 K) | 4.8 | about 21 s |
| Working | rate ratio = exp[ (Ea / R) x (1 / T1 minus 1 / T2) ], with Ea / R = 60,000 / 8.314 = 7,217 K | Time varies as 1 / rate |
Check for 10 degrees C against 20: exp[7,217 x (1/283.15 minus 1/293.15)] = exp(0.87) = 2.4, so it is 2.4 times slower. Real clock reactions also depend on the chemistry of the clouding step.
Source: Royal Society of Chemistry, The effect of temperature on reaction rate (sodium thiosulfate and acid), https://edu.rsc.org/experiments/the-effect-of-temperature-on-reaction-rate/448.article (time for a cross to disappear measured at five temperatures from 15 to 55 degrees C; rate taken as 1 / time)- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- Royal Society of Chemistry, The effect of temperature on reaction rate (sodium thiosulfate and acid) · web
3.2 More reactant per volume and more exposed surface mean more collisions, which is why dust can burn in an instant and a log cannot
A match flares in pure oxygen because oxygen is about five times more concentrated there than in air, so collisions with the burning surface are five times more frequent. Pressing gases into a smaller volume has the same effect.
Solids react only at their surface. A cube 1 cm on a side has 6 cm2 of surface. Cut it into cubes 1 mm on a side and you have 1,000 cubes with 60 cm2 in all, ten times as much. Grind it to dust 10 micrometres across and the same cubic centimetre exposes 6,000 cm2, about 0.6 m2. This is why a nail only rusts slowly while fine iron powder in a hand-warmer sachet heats up within minutes, and why lump sugar takes longer than icing sugar to dissolve.
The same fact has a dark side. A heap of flour will not burn easily, but a cloud of flour, mixed with air and lit by one spark, burns through its whole volume in a fraction of a second, and the hot gases push outward as a blast. Grain mills, coal stores and sugar and aluminium works control dust for this reason.
| Piece size | Number of pieces | Total surface | Effect |
|---|---|---|---|
| 1 cm cube | 1 | 6 cm2 | Burns slowly from the outside |
| 1 mm cubes | 1,000 | 60 cm2 | Ten times the surface; reacts ten times faster, other things equal |
| 10 micrometre grains | 1 billion | 6,000 cm2 (0.6 m2) | Dust: reacts in a flash if mixed with air |
Surface of N cubes of side s is N x 6 x s^2; for a total volume of 1 cm3, N x s^3 = 1.
Source: Encyclopaedia Britannica, Gunpowder, https://www.britannica.com/technology/gunpowder (black powder is saltpetre, sulphur and charcoal, about 75, 11 and 14 per cent; about 40 per cent gaseous and 60 per cent solid products)- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- Encyclopaedia Britannica, Gunpowder · web
- Encyclopaedia Britannica, Dynamite · web
3.3 A catalyst lowers the barrier and is not used up, and two cases show its reach: an enzyme in a potato and chlorine in the stratosphere
A catalyst is a substance that makes a reaction faster by offering a different route with a lower barrier, and is released unchanged at the end. It speeds up the forward and backward reactions equally, so it cannot push a reaction beyond where it would end anyway.
Hydrogen peroxide, the mild bleach in a first-aid kit, slowly breaks down: 2 H2O2 → 2 H2O + O2. A drop of peroxide on a slice of raw potato fizzes at once, because the potato holds catalase, an enzyme, which is a protein catalyst. The table lists typical activation energies: about 75 kJ per mole alone, about 49 on platinum and about 8 with catalase. Because the barrier sits in an exponent, the gain is vast. At body temperature, cutting the barrier by 67 kJ per mole speeds the reaction by exp(67,000 / (8.314 x 310)), about 2 x 10^11 times. Each catalase enzyme can handle millions of peroxide molecules a second. Living things depend on enzymes for this reason.
A catalyst can also do damage. A chlorine atom freed from a CFC high in the stratosphere reacts with ozone to form chlorine monoxide and oxygen, and the monoxide reacts with an oxygen atom to give back the chlorine atom. The net effect is the loss of ozone, and the chlorine is free to start over, so a single atom can destroy thousands of ozone molecules. The Montreal Protocol of 1987 phased CFCs out. NOAA reports that the ozone layer is on course to recover to its 1980 values by the middle of this century, with the Antarctic hole closing around 2060. See the science node Catalysis, and Understanding Chemicals for industrial catalysts.
| Route | Activation energy | Speed relative to no catalyst |
|---|---|---|
| No catalyst | about 75 kJ per mol | 1 |
| Platinum surface | about 49 kJ per mol | about 2 x 10^4 times faster |
| Catalase enzyme | about 8 kJ per mol | about 2 x 10^11 times faster |
Speed factor = exp[(Ea,old minus Ea,new) / RT], with RT = 8.314 x 310 = 2,577 J per mol; platinum: exp(26,000 / 2,577) = exp(10.1) = 2.4 x 10^4. The catalase barrier is given as below 8 kJ per mol, so its factor is a lower limit.
Source: Purdue University, Chemistry Education, Demonstration 19.6: The catalytic decomposition of hydrogen peroxide, https://chemed.chem.purdue.edu/genchem/demosheets/19.6.html (activation energy about 75 kJ/mol without catalyst, about 49 kJ/mol on platinum, below 8 kJ/mol with catalase; enthalpy minus 196.1 kJ for 2 H2O2; checked 2026)- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- NOAA, United Nations report: Ozone layer recovery on track (2023) · web
- Purdue University, Chemistry Education, Demonstration 19.6: The catalytic decomposition of hydrogen peroxide · web
3.4 Many reactions run in both directions until the forward and backward rates match, and Le Chatelier's rule predicts how a push moves that balance
Open a bottle of soda and bubbles stream out. Inside the sealed bottle there were none, though carbon dioxide was present both dissolved and as gas above the liquid. Molecules were leaving the liquid and returning at the same rate, so nothing changed overall. This is dynamic equilibrium: both processes continue, but their rates are equal and the amounts stay constant. Opening the cap drops the pressure, the return slows, and the gas escapes.
Many chemical reactions behave like this, written with a double arrow, for example N2O4 ⇌ 2 NO2, a colourless gas turning to a brown one. The equilibrium constant K, the ratio of product to reactant amounts raised to their coefficients, says where the balance settles. A large K means the reaction goes nearly to completion and a small K means it hardly starts.
Henri Le Chatelier stated a rule in 1884: if a system at equilibrium is disturbed, it shifts to oppose the disturbance. Add reactant and it makes more product. Squeeze it and it favours the side with fewer gas molecules. Heat it and it favours the endothermic direction. A catalyst changes none of this; it only helps the system arrive sooner. See the science node Chemical equilibrium (Le Chatelier's principle). Understanding Engineering, in the module Matter and process, shows how plants use the rule to choose pressure and temperature.
| Disturbance | Shift | Why | Observed colour |
|---|---|---|---|
| Heat the sealed tube | To NO2 | Rightward direction takes in heat, which opposes the heating | Darker brown |
| Cool in ice water | To N2O4 | Leftward direction gives out heat | Paler |
| Squeeze the gas | To N2O4 | One molecule instead of two reduces the pressure | Paler after the first flash of darker colour |
| Add NO2 | To N2O4 | Uses up the extra NO2 | Settles at a similar colour |
| Add a catalyst | None | Both rates rise equally | Same, reached sooner |
Standard textbook values; the equilibrium constant depends on temperature.
Source: Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook, values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them- Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 13, 'Chemical Reactions'
- Rounded standard reference values for molar masses, bond energies, enthalpies of formation, heating values, activation energies and equilibrium constants, as tabulated in the CRC Handbook of Chemistry and Physics and the NIST Chemistry WebBook · values quoted to two or three figures as round numbers for estimates; bond energies, heating values and activation energies spot-checked in 2026 against the sources listed beside them
See it in the table
H₂O WaterAl AluminiumPt PlatinumSu SugarCl2 ChlorineH2O2 Hydrogen peroxideH2 HydrogenO2 OxygenCO2 Carbon dioxideCheck your understanding
A reaction with an activation energy of 60 kJ per mole is warmed from 20 to 30 degrees C. Roughly what happens to its rate?
The Arrhenius factor gives about 2.25, because the share of collisions with enough energy rises steeply even though total collisions rise by only a couple of per cent.A catalyst is added to a reaction already at equilibrium. What happens?
A catalyst lowers the barrier in both directions equally, so the ratio of products to reactants at equilibrium is the same.A 1 cm cube of iron is ground to a fine powder. Why does it now rust or burn much faster?
Reactions happen at the surface. Splitting the same mass into small grains greatly increases the area, so there are many more collisions per second.