Second law of thermodynamics: Technologies
Technologies
The technologies that rely on it, and how each one uses it
Limits 27- ICE Internal combustion engines and gensets An engine cannot turn all its heat into work, so the heat it must reject leaves as hot exhaust and in the cooling water.
- FC Fuel cells Only the free energy of the reaction can become electricity; the rest of the reaction's energy must leave as heat, even in a perfect cell.
- Elz Electrolysers Splitting water needs a minimum electrical work, and any voltage above what the reaction needs leaves the cell as heat.
- DC Data centres Erasing information must give off a minimum amount of heat, a floor set by the second law, though today's chips give off far more.
- Crn Lifting crane Friction in pulleys and bearings turns part of the input work into heat that cannot be turned back, so no crane returns all the effort put in.
- CCS Carbon capture and storage Separating a dilute gas from a mixture takes a minimum amount of work, so capture always costs energy, and more for dilute streams.
- DAC Direct air capture Separating carbon dioxide from air at 400 ppm takes at least about 20 kJ per mole, a floor set by the second law.
- AGS Advanced geothermal Water at a couple of hundred degrees can only turn a modest share of its heat into electricity.
- CAES Compressed-air and CO2 storage Heat of compression that is cooled away cannot be fully recovered, one reason Huntorf's round-trip efficiency is estimated at about 33%.
- CB Carnot batteries Heat flows by itself only from hot to cold, as Clausius stated in 1850; a heat pump must spend work to pump it uphill, and every irreversible step in that round trip loses energy.
Show 17 more
- Fly Flywheels and small mechanical stores Every bearing and drag loss turns some of the rotor's motion into heat, so a flywheel slowly runs down when left alone.
- GSH Geothermal direct use and ground-source heat pumps Heat flows by itself only from hot to cold, so a heat pump must spend electricity to lift mild ground heat to room temperature.
- GeP Geothermal power plants Heat flows from hot to cold, and a moderately hot fluid can turn only a modest share of its heat into work.
- H2S Hydrogen storage Real compressors need more than the ideal minimum work: DOE measured 1.7 to 6.4 kWh/kg for on-site compression, against a theoretical 1.36 kWh/kg to reach 700 bar.
- LAES Liquid air storage Liquefying air takes more work than expansion gives back, so round-trip efficiency is about 50 to 60%, or 60 to 70% with advanced heat recovery.
- MH Micro energy harvesting Carnot efficiency is small for small temperature differences: body to cool room gives only 5.5%.
- Ref Refining and reforming Separating a mixture has a minimum energy cost; real columns use several times that minimum.
- ICV Combustion road vehicles Most fuel energy must leave as waste heat in the exhaust and cooling water.
- SHS Sensible heat storage Stored heat only flows from hot to cold, so a store loses value as it cools towards its surroundings and cannot give back more than a fraction as electricity.
- Shr Shared and district heat reuse Heat flows on its own only from hotter to colder, so surplus heat cooler than the network water cannot enter it without a heat pump, which needs work, usually electricity, to lift it.
- ST Steam turbines and thermal power plants Some heat must always be rejected to a cold sink; in coal and nuclear steam plants about two thirds of the energy is lost this way.
- Data-centre server Almost all electrical power ends as low-grade heat that fans and cooling must carry away, which caps the power of a rack.
- Heat exchanger Heat flows only from hot to cold, so the cold liquid can be warmed only towards the hot liquid's inlet temperature.
- Industrial air compressor Compression work cannot be recovered once the heat is lost, so most input ends as heat.
- Steam turbine Some heat must be rejected to a cold sink, which is why a condenser is needed.
- RTG Radioisotope thermoelectric generator Like any heat engine, an RTG can turn only part of its heat into work and must reject the rest, so most of the heat is radiated away.
- RO Reverse osmosis desalination Separating salt from water lowers entropy, so it takes a minimum amount of work, about 1 kWh per cubic metre for typical sea water.
- ST Steam turbines and thermal power plants A steam plant must pass much of its heat to a condenser, because no engine can turn all the heat it takes in into work.
- CB Carnot batteries Turning stored heat back into electricity is bounded by the second law, so a Carnot battery returns only part of the energy put in.
- GeP Geothermal power plants Geothermal fluids are only moderately hot, so the second law allows only a small share of their heat to become electricity.
- AGS Advanced geothermal Hot rock deep underground gives a hotter source than shallow geothermal fluids, and the second law means a hotter source lets a larger share of the heat become electricity.
- HP Heat pumps, air conditioning and refrigeration Heat will not flow from cold to warm on its own, so a heat pump must be supplied with work to push it uphill.
- GSH Geothermal direct use and ground-source heat pumps A ground-source heat pump needs work to lift heat from the cool ground to the warmer house, since heat will not flow that way by itself.
- Bld Energy in buildings Heat flows on its own only from warm to cold, so cooling a building, or heating it with outdoor heat, needs a heat pump and work.
- Shr Shared and district heat reuse Waste heat is often too cool to use directly, and raising it to a useful temperature takes a heat pump and work.
- HX Heat exchangers and pinch integration Heat passes only from the hotter stream to the colder one, so exchangers are laid out to keep a temperature difference along their whole length.
- Vul Vulcanisation of rubber A stretched rubber network pulls back because its chains tend to return to more disordered, coiled shapes: its elasticity comes from entropy.
- Air conditioner Heat only flows from cold to warm if work is done, which is the electricity the compressor takes.
- Refrigerator Moving heat from the cold cabinet to the warm kitchen needs work, the electricity of the compressor.
as of 2026-11-11