Material Insights · Understanding the Material World

Open-hearth steelmaking

A regenerative furnace melts pig iron and scrap slowly, giving steel of controlled quality.

Making materials · Metals · No. 394

  • Steam and steel
  • Readiness 9 of 9
  • Process
Making materials · Technology

A furnace that recycled its own exhaust heat made nine tenths of British and American steel until 1950.

Chart: Illustration: Open-hearth steelmaking

Where it comes from

Chart: Map of where it comes from

Friedrich and William Siemens built a furnace that stored exhaust heat in brickwork to preheat the incoming air. In 1864 Pierre and Emile Martin used one to make steel in France.

Three things to know
  1. The open hearth could melt any mix of molten pig iron and cold scrap, so steelworks could melt scrap as well as fresh iron.
  2. A heat took 12 to 18 hours, long enough for steelmakers to test the metal and adjust it before tapping.
  3. Oxygen steelmaking replaced it from about 1960; Russia shut its last open hearth in 2018 and India's SAIL in 2020.
The journey
  1. 1 ChargeMolten pig iron, cold scrap, iron ore and limestone go onto a shallow hearth
  2. 2 RegeneratorsBrick chambers heated by the exhaust warm the incoming air and gas
  3. 3 MeltingThe hot flame sweeps over the charge and melts it
  4. 4 RefiningOver many hours oxygen burns out carbon and limestone takes up impurities as slag
  5. 5 TappingSteel is sampled until it is right, then poured into ladles
Go deeper pick a tab to open it in full