Material Insights · Understanding the Material World

Heat exchanger: Interventions

Interventions

Changes that would cut emissions or material use, by lever and life stage, with effect per unit, readiness, adoption, evidence and who acts

LeverLife stageChangeEffect per unitReadinessAdoptionWho actsSource
SubstituteComponents designMake plates and frames from low-emission stainless and carbon steelUp to 60% lower emissions on the delivered unit against average material alternatives, cradle to grave, for five TL10 unitsdeployed in a 2025 deliveryOne reported project; no share of units foundHeat exchanger makers and steel mills[21]
DesignComponents designSpecify a higher allowed pressure drop, so that fewer plates are neededUp to 10% saving in purchase cost at 50 kPa instead of 20 kPa; pumping cost rises, and the mass saved is not givendeployedA rule of thumb of 50 to 70 kPa is given for HVAC coolingBuyers, consultants and makers[8]
SubstituteComponents designUse a plate unit in place of a shell and tube unit where pressure allowsThe maker claims less than 1/16 of the total weight and 1/10 of the floor spacedeployedPlate and frame units are a large part of the heat exchanger market; share of duties switched not foundPlant designers[6][27]
CircularityEnd of lifeRecondition plates and replace gaskets, then recycle the metal at the endKeeps the plate pack in service (an audited fleet reached 11 years); about 70% of stainless steel is recycled at end of lifedeployedReconditioning was recommended for 39 units in one auditOperators and service providers[26][19]
Business modelUseAudit the condition of gaskets and plates to schedule servicePredicts gasket life, which varies with operating conditions; no emissions figure givendeployedOffered by Alfa Laval for plate heat exchangersMakers and operators[26]

as of 2026-11-17

Sources

  1. Gasketed plate heat exchangers: GPHE vs shell-and-tube Alfa Laval
  2. Save now, save later: what is the ideal pressure drop to specify for gasketed plate heat exchangers in HVAC applications Alfa Laval
  3. The Global Life Cycle of Stainless Steels International Stainless Steel Forum (worldstainless)
  4. Collaborative innovation cuts heat exchanger carbon footprint by 60 percent for hospital in Helsinki Alfa Laval, 2025
  5. Predicting gasket lifetime with Alfa Laval Performance Audit (Jubail, Saudi Arabia) Alfa Laval, 2025
  6. Plate Heat Exchanger vs Shell & Tube Heat Exchanger: Key Differences Alfa Laval India, 2026