Material Insights · Understanding the Material World

Matter and bonding: phases, elements, compounds, solutions: Bonds: why atoms stick together

All courses / Understanding Science / Module 10: Matter and bonding: phases, elements, compounds, solutions Part 3 of 6

Bonds: why atoms stick together

Atoms join because the joined arrangement has less energy than the separate atoms, and the glue is the electric force. How the outer electrons are handed over, pooled or shared gives three kinds of bond, each with its own set of properties.

3.1 Atoms bond because the joined state has lower energy, and electron-dot pictures count the outer electrons that do it

Two atoms far apart do not feel each other much. Bring them close and each nucleus begins to attract the other's electrons, while nuclei repel nuclei and electrons repel electrons. At one particular distance the attractions win by the largest margin and the energy is lowest. Pulling them apart costs that energy, and that cost is the bond energy. A bond is not a thing but a lowered energy.

Only the outermost, or valence, electrons take part, because the inner ones are held close to the nucleus. In 1916 Gilbert Lewis pictured this as dots around the atom's symbol, one dot for each valence electron. Lewis and Walther Kossel saw that atoms behave as if they were aiming for an outer shell of eight electrons, as the noble gases have, or two for the first shell. This is the octet rule, a shortcut and not a law. It works best for carbon, nitrogen, oxygen and fluorine, and many heavier atoms break it.

The dots tell you how atoms will combine. A metal with one to three valence electrons is likely to lose them. A non-metal one to three short of eight is likely to gain or share. If gained and lost numbers match, you can predict the formula. The shared counts also predict the bonds a non-metal makes: eight minus its valence electrons.

Data Worked estimate: predicting formulas from valence electrons (calculated)
Atom or pairValence electronsRulePredicted formulaReal compound
Sodium and chlorine1 and 7Na gives 1, Cl takes 1NaClTable salt
Magnesium and chlorine2 and 7Mg gives 2, each Cl takes 1MgCl2Bittern salt
Magnesium and oxygen2 and 6Mg gives 2, O takes 2MgOMagnesia
Aluminium and fluorine3 and 7Al gives 3, each F takes 1AlF3Aluminium fluoride, added to smelter baths
Hydrogen and oxygen1 and 6O needs 8 - 6 = 2 bondsH2OWater
Hydrogen and nitrogen1 and 5N needs 8 - 5 = 3 bondsNH3Ammonia
Hydrogen and carbon1 and 4C needs 8 - 4 = 4 bondsCH4Methane
Carbon and oxygen4 and 6C needs 4, O needs 2: two double bondsCO2Carbon dioxide

The rule counts electrons only. Whether the atoms transfer or share them is the question of the next three sections.

  • Hewitt, Lyons, Suchocki and Yeh, Conceptual Integrated Science, 2nd edition (Pearson, 2013) · ch. 12, 'Chemical Bonds and Mixtures'

3.2 An ionic bond is the pull between ions of opposite charge, and X-ray crystallography showed that salt has no molecules

Put a piece of sodium in chlorine gas and it burns with a yellow flame, leaving white crystals of salt. Sodium gives up its one outer electron to chlorine, which has room for one more. The atoms become charged: sodium loses a negative charge and becomes Na+, chlorine becomes Cl-. Opposite charges attract with the same Coulomb force the module on electricity and magnetism described.

A single pair of ions is not salt. Each ion pulls on every ion of opposite charge around it and pushes away those of the same sign. The lowest-energy arrangement is a three-dimensional lattice in which every ion has six nearest neighbours of the opposite charge, one on each side of it along three perpendicular lines. No ion belongs to one partner, so a salt crystal has no separate NaCl molecules. In 1913 William Henry Bragg and his son William Lawrence Bragg showed this by firing X-rays at crystals and working out the pattern of the atoms from the reflected beams. The Nobel committee of 1915 noted that the crystals proved to be atomic lattices, not molecular ones. See X-ray diffraction by crystals.

One isolated Na+ and Cl- pair at the observed spacing of 0.282 nm holds about 493 kJ per mole of electrical energy. Summing every neighbour in the lattice multiplies this by 1.75, and the push of touching electron clouds trims it back to the measured 787 kJ per mole. That is why salt melts at 801 degrees C. Double the charges to Mg2+ and O2- and the measured lattice energy rises nearly fivefold, to 3,791 kJ per mole, and magnesia melts at about 2,850 degrees C.

Ionic solids are brittle. Slide one layer by half a step and like charges meet, so the crystal repels itself and splits. They conduct only when molten or dissolved, because only then do ions move.

Data Worked estimate: the electrical energy of an ionic crystal (calculated)
StepWorkingResult
Energy of one Na+ and Cl- pair, k x e x e / r8.99 x 10^9 x (1.602 x 10^-19)^2 / 2.82 x 10^-10 m8.2 x 10^-19 J, 5.1 eV
Per mole of pairs8.2 x 10^-19 J x 6.022 x 10^23493 kJ per mole
Add the whole lattice with the geometric factor 1.75493 x 1.75about 860 kJ per mole
Measured lattice energy of NaCltabulated value787 kJ per mole
Same pair for Mg2+ and O2-, charges doubled, spacing 0.210 nm4 x 8.99 x 10^9 x (1.602 x 10^-19)^2 / 2.10 x 10^-10 x 6.022 x 10^23about 2,650 kJ per mole
Add the whole lattice with the same factor 1.752,650 x 1.75about 4,630 kJ per mole
Measured lattice energy of MgOtabulated value3,791 kJ per mole

The point-charge sum overshoots, by about 9 per cent for salt and about 22 per cent for magnesia (calculated), because electron clouds repel when ions touch and magnesia is not wholly ionic. Both sums still land within a quarter of the measured values, and both show the fivefold jump that doubled charges should give.

Source: Purdue University, Chemistry Education, Lattice energy, https://chemed.chem.purdue.edu/genchem/topicreview/bp/ch7/lattice.php (lattice energy of NaCl 787.3 kJ/mol; Mg2+ with O2- 3791 kJ/mol; the bond is stronger for larger charges and smaller ions)

3.3 A metal is a lattice of positive ions in a shared sea of electrons, and most metals have to be won from their oxides

Hold a steel spoon in hot tea and the handle warms within seconds. Hammer a copper pot and it dents instead of shattering. Both traits come from the metallic bond. Metal atoms have few valence electrons, held loosely, so in the solid they leave their atoms and move through the whole lattice. The metal is then a regular array of positive ions held together by a cloud of electrons that belongs to none of them. The cloud carries current and heat, which is why metals are good conductors, and it lets layers of ions shift past one another without breaking the bond, which is why metals are malleable and ductile.

The same loose hold on outer electrons explains why metals are seldom found as metals. Oxygen and sulphur take those electrons readily, so over geological time most metal atoms ended up as ions in oxide and sulphide ores, and only unreactive ones such as gold turn up native. Extracting a metal means handing the electrons back. Carbon in a blast furnace does this for iron, as the engineering module Matter at the atomic scale: bonds, reactions and process engineering shows. Aluminium clings to oxygen too hard for carbon, so alumina is dissolved in molten cryolite and split by electric current. See Thermodynamics of ore reduction (Ellingham diagram).

The table checks this with the electrical charge needed, using Faraday's laws of electrolysis: each aluminium ion needs three electrons, and one mole of electrons carries 96,485 coulombs. The result matches the real smelter within a few per cent.

Data Worked estimate: the electricity to make 1 kg of aluminium (calculated)
StepWorkingResult
Moles of aluminium1,000 g / 26.98 g per mole37.1 mol
Moles of electrons, 3 per ion37.1 mol x 3111 mol
Charge111 mol x 96,485 C per mol1.07 x 10^7 C
Energy at about 4.1 V per cell1.07 x 10^7 C x 4.1 V4.40 x 10^7 J
Allow for 95 per cent current efficiency4.40 x 10^7 J / 0.954.63 x 10^7 J
In kWh4.63 x 10^7 J / 3.6 x 10^6 J per kWh12.9 kWh
Reported by the Jharsuguda smelter, 202412,985 kWh per tonne13.0 kWh per kg
Alumina needed1 kg x 101.96 / (2 x 26.98)1.89 kg

Modern cells run at about 4.1 to 4.25 V. Most of that drives current through the resistive bath, which also keeps it molten, and about 5 per cent of the current is lost to side reactions.

Source: ICSOBA 2024, paper AL21, Systematic approaches to reduce specific DC power consumption at Vedanta Jharsuguda smelter, https://icsoba.org/assets/files/publications/2024/Papers/AL21 - Systematic Approaches to Reduce Specific DC Power Consumption at Vedanta Jharsuguda Smelter.pdf (typically 4.15 to 4.25 V across a cell in a 330 kA smelter; Plant-1 specific DC energy 12,985 kWh per tonne of aluminium in FY2024; cell voltages 4.07 to 4.14 V with current efficiency about 95 per cent)

3.4 A covalent bond shares a pair of electrons between two nuclei, and a triple bond makes nitrogen almost inert

When two non-metal atoms meet, neither can take the other's electron without cost, so they share. In a hydrogen molecule, the two electrons sit mostly between the two nuclei, pulling both. Each nucleus feels two electrons, as if it had a full first shell. The shared pair is the covalent bond. Share two pairs and you have a double bond, three pairs a triple bond. More shared pairs pull the nuclei closer and hold them harder.

The numbers show this. A single carbon-carbon bond has a length of about 0.154 nm and an energy of about 347 kJ per mole. The double bond is shorter, about 0.134 nm, and stronger at about 614 kJ per mole. The triple bond is shorter again at about 0.120 nm and about 839 kJ per mole. Air is 78 per cent nitrogen, made of N2 molecules, with a triple bond of 945 kJ per mole, among the strongest bonds known between two atoms. That one number explains why nitrogen sits idly in the air and why fertiliser makers need high temperature, high pressure and a catalyst to split it. Understanding Chemicals picks this up in Heavy inorganics.

Covalent substances come in two kinds. Small molecules, like water or methane, have strong bonds inside the molecule but weak attractions between molecules, so they melt and boil easily. Network solids, like diamond and quartz, have bonds running through the whole crystal, so melting means breaking real bonds. Quartz melts only near 1,700 degrees C. Graphite, also all carbon, has strong bonds in sheets that slide over one another, which makes pencil lead.

Data Worked estimate: bond energies against thermal energy (calculated)
BondEnergy (kJ per mole)Energy per bond (eV)Multiple of kT at 300 K (0.0259 eV)
Cl-Cl2432.597
C-C single3473.6139
O-H in water4634.8186
O=O in oxygen4985.2200
C=C double6146.4246
N-N triple, in nitrogen9459.8379

Energy per bond in eV is kJ per mole divided by 96.5. Average values differ by a few per cent between tables. A bond survives ordinary temperatures because it takes hundreds of times the typical thermal energy to break. Lightning and engines reach the temperatures at which N2 starts to react with O2.

Source: University of Texas at Austin, General Chemistry help sheet, Bond energies, https://gchem.cm.utexas.edu/pdf/helpsheets/bondenergies.pdf (average bond energies in kJ/mol: C-C 346, C=C 602, C triple C 835, N triple N 945, O-H 463, O=O 498, Cl-Cl 242; other tables give C=C near 614 and C triple C near 839)

See it in the table

H₂O WaterCu CopperAl AluminiumSt SteelAu GoldGr GraphiteNaCl SaltTea TeaCl2 ChlorineH2 HydrogenO2 OxygenEl Electricity

Check your understanding

Using valence electrons, which formula would you predict for the compound of calcium (2 valence electrons) and chlorine (7)?

Calcium gives two electrons and each chlorine takes one, so two chlorines are needed: CaCl2.

Why does a salt crystal shatter when struck, while a copper sheet bends?

In an ionic crystal a slip puts ions of the same sign face to face. In a metal the shared electrons hold the ions together in any position.

Bragg's work on salt showed that

The pattern of X-ray reflections fitted two interlocking lattices of ions, so there are no NaCl molecules to pick out.
← Part 2: Phases of matter, phase changes and densityMark read · Part 4: Electronegativity, shape and polarity: why water is bent and polar →