Beam theory: Technologies
Technologies
The technologies that rely on it, and how each one uses it
Relied on by 17- IFB Iron-framed building Its iron beams and girders are sized so that the bending stress under the floor loads stays safe and the sag stays small.
- Sky Steel-frame skyscraper Steel I-beams put most of their metal far from the neutral axis, where it resists bending best, and the frame is checked beam by beam.
- RCo Reinforced concrete A bent beam is stretched on one face, so steel bars are placed there to carry the tension that concrete cannot.
- PSC Prestressed concrete Tensioned steel squeezes the beam's lower face in advance, so the stretching caused by bending only reduces that squeeze instead of cracking the concrete.
- CLT Cross-laminated timber Layers glued crosswise make a panel that is stiff in bending in both directions, and its depth sets how far it can span.
- SBr Iron suspension bridge The deck between hangers works as a beam, and a stiffening girder stops it bending too much under moving loads.
- CSB Cable-stayed bridge The deck is a beam held up at many points by the stays, so the bending it must carry between them stays small.
- IHS Iron and steel ship hull In waves the whole hull bends like a long beam, and its deck and bottom plating are sized to carry that bending.
- Irn Ironclad warship In principle terms, its heavy hull also bends like a long beam in waves, and the structure is sized for that.
- UG Underground railway Cut-and-cover tunnels are roofed with beams or girders that must carry the street and buildings above in bending.
Show 7 more
- TSh Tunnelling shield The lining rings built behind the shield bend under uneven ground pressure, and their thickness is chosen to keep that bending safe.
- Cargo ship The hull acts as a long beam bent by waves, which sets the plate thickness and steel mass.
- Corrugated box The fluting holds the two liners apart, so the board bends like a deep, light beam.
- Precast concrete products Beams, slabs and sleepers carry load by bending; steel sits where the part is stretched.
- Wind turbine tower The tower is a cantilever beam: stiffness and strength grow with wall thickness and diameter, so wider shells carry the load with less steel.
- Rly Railway (iron track network) Engineers model a rail as a continuous beam on elastic supports, the sleepers, so a wheel load over one sleeper is shared with its neighbours through the rail's bending.
- TCr Tower crane The long jib bends under the load like a cantilever beam, so it is built as a deep, light steel lattice.
as of 2026-11-10